May 23, 2024

The Enterprise News

Business News for the Modern Peeps

Why My Linksys Velop Stopped Working After Factory Reset?

You may at any time need to give your technical device a new start. Linksys Velop is not an exception here. If it is bothering you for some reason or you simply want to start all over again from scratch, you’ll need to reset it to the default values. After you factory reset Velop, you must configure it again from the very beginning. You can use the web interface via linksyssmartwifi URL to complete the installation.

It so happens that users complain that the Velop stopped working after it is reset. Has this happened to you as well? Well, through this guide, we’ll shed light on why your Velop is giving you trouble and what you need to do to get it up and working.

Velop Not Working After Reset: Try This!

If your Velop is not working after you reset it, then there is a high possibility that you haven’t reset it correctly. Thus, the very first thing that you should do is to reset it once again. This time you should execute the correct steps to get the job done.

For your assistance, we’ve mentioned the correct steps for the Linksys Velop reset. Follow them and have your Velop running on the default values.

How to Reset Linksys Velop?

  1. Firstly, check that your Velop is receiving a steady power and is fully powered up.
  2. You also need to make sure that no other cable is connected to it. Let only the Power adapter stay connected.
  3. Now, with the help of a sharp and pointed object such as a straightened paper clip, press and hold the Reset button that’s located inside a hole on the Velop device.
  4. Hold it for some time. We suggest you holding it until the power light blinks.
  5. Give your device some time now. It’ll reboot itself. Upon restarting, it will have the default settings running on it.

You should now use the web interface to log in and complete Linksys Velop setup. In case the Velop isn’t working even now then you should try the solutions given ahead.

Check the Power Connection

One of the primary reasons that your Linksys Velop has stopped working is inadequate power to it. If the power cable or the power socket is damaged then your device will not work properly. You are now suggested to check the power socket and the power cable. At times the damage can’t be seen directly to the eyes. So, you should try using alternative wall outlet to plug in the Velop. Besides, if there are fluctuations in the electricity supply, you should use a UPS.

Wisely Connect to Modem

You might have connected the Linksys Velop to the modem or the DSL gateway directly. You are required to check this connection now. A fault in this connection can render your Velop to be in non-working condition. The LAN cable that’s used to join both devices has to be in right condition. When we say right condition, we mean to use a cable that’s not damaged. Besides check that the cable is not loose. By any chance, you have connected the Linksys Velop and WiFi modem wirelessly, then it is to be ensured that they are placed in close proximity such that it is easy for them to communicate smoothly.

Wrap Up

With the hope that the solutions listed in this guide are sufficient to help you get your Linksys Velop in working condition, here we wrap it up. We expect that your device is all set to provide you with reliable internet. Get connected and have seamless experience online.